
The
machine must be taken on a journey of sufficient length to warm up the final
drive to normal operating temperature before the oil is drained.
With the machine supported on its center stand on level ground, remove the
filter and drain plugs and allow the oil to drain into a suitable container.
Use a sheet of cardboard to keep the oil off the rear wheel and tire. Renew
the plug sealing washers if they are damaged or flattened, and clean both
plugs; wipe any metal particles from the drain plug magnetic insert. When
the oil has fully drained, refit the drain plug, tightening it to the
specified torque setting and pour in the correct amount of the specified
type and viscosity of oil.
Check the oil level as described in the Minor Service - Check the final case oil level
Next Section: 4. Change the front fork oil
Final drive drain plug is situated on underside of final drive case