
Electrical system | ||||
Voltage | 12 Volt | |||
Earth (ground) | Negative ( - ) | |||
Battery | ||||
Manufacturer | BMW - Mareg | |||
Capacity: | ||||
Standard | models up to 1986 | 20 Ah | ||
Standard | models from 1987 on | 25 Ah | ||
Standard | optional all models | 30 Ah (may be fitted to K100LT as standard) | ||
Electrolyte specific gravity | 1.280 @ 20°C (68°F) | |||
Altenator | ||||
Type | Bosch 0.120.339.546. G1 -14V 33A 27 | |||
Rated output | 460W/14V 33Ah | |||
Reduction ratio | 1.5:1 | |||
Maximum speed | 12300 rpm | |||
Voltage regulator | Bosch 1.197.311.001. EL 14V 4C | |||
Charge starts at | 950 ± 50 rpm | |||
Regulated voltage | 13.7 - 14.5 volts | |||
Stator winding resistance - across phase outputs | 0.28 ohm ± 10%@ 60°C (140°F) | |||
Resistance between slip rings - exciter winding | 4.0 ohm ± 10% @ 60°C (140°F) | |||
Stator/rotor air gap | 0.22 mm (0.0087 in) | |||
Rotor maximum runout at claw poles | 0.05 mm (0.0020 in) | |||
Slip ring maximum runout | 0.03 mm (0.0012 in) | |||
Slip ring 0D | Standard | 27.8 mm (1.0945 in) | ||
Service limit | 26.8 mm (1.0551 in) | |||
Brush projection | Standard | 10 mm (0.3937 in) | ||
Service limit | 5 mm (0.1969 in) | |||
Starter motor | ||||
Type | Nippon Denso 028000 - 8990 | |||
Power | 0.7kW (1 hp) | |||
Reduction ratio - overall | 27:1 | |||
Lockout effective above | 711 rpm | |||
Brush length - see text | Standard - approximate | 12 mm (0.4724 in) | ||
Service limit | 50% of new length | |||
Fuses - Circuit protected | Fuse rating | |||
1 Instrument cluster, stop and tail lamps | 7.5 Amp | |||
2 Parking lamp | 7.5 Amp | |||
3 Turn signals, clock | 15 Amp | |||
4 Power socket - where fitted | 15 Amp | |||
5 Optional extra equipment - where fitted | 15 Amp | |||
6 Fuel pump | 7.5 Amp | |||
7 Horns, radiator fan | 15 Amp | |||
Bulbs | ||||
Headlamp | 12V, 60/55W-H4 | |||
Parking lamps | 12V, 4W | |||
Tail lamp | 12V, 10W | |||
Stop lamp | 12V, 21W | |||
Turn signal lamps | 12V, 21W | |||
Turn signal warning lamps | 12V, 4W | |||
All other warning and instrument illuminating lamps | 12V, 3W | |||
Torque wrench settings | 75 models | 100 models | ||
Component | Nm | lbf ft | Nm | lbf ft |
Alternator shock absorber body retaining nut | 50 ± 6 | 37 ± 4.5 | 31 | 23 |
Alternator mounting bolts | 22 ± 3 | 16 ± 2 | 14 ± N/Av | N/Av |
Starter motor mounting bolts | 7 ± 1 | 5 ± 0.5 | 6 | 4.5 |
Next Section: 1 - General description
Bulb H4 55/60W for headlight
Bulb 21W for stop or turn signal lamp
European fuses
Different type of blade fuses
Sketch of a GOOD and a BLOWN fuse